=== Finishing the board ===

  * On the soldering side of some boards, you need to put down some additional wires or trimpots
  * The wires are indicated by grey curvy lines on the soldering side (e.g. the phaseur needs 8 or so). Just cut a piece of wire the right length, strip the ends 1/16" inch, and solder it onto the twisted wire joints.
  * For trimpots, solder two of the leads (the center one and one other) directly to the two twisted wire joints on the solder-side. Make sure it won't wiggle around.


Next:[[Drilling]]